Androidomatic Keyer
Morse code keyer
This project enables ham radio operators to use their android phones as memory
keyers to send CW or Hellschreiber signals using any radio transmitter capable
of putting out a carrier wave. The application presents a list of editable
phrases, then plays the selected phrase as morse code (or Hellschriber) through
the sound output. The audible tones produced may be used directly if a modulated
signal is desired, but the sound can also be routed through an easy-to-build
interface which converts this sound into on/off keying for the transmitter.
keyers to send CW or Hellschreiber signals using any radio transmitter capable
of putting out a carrier wave. The application presents a list of editable
phrases, then plays the selected phrase as morse code (or Hellschriber) through
the sound output. The audible tones produced may be used directly if a modulated
signal is desired, but the sound can also be routed through an easy-to-build
interface which converts this sound into on/off keying for the transmitter.
- 授權條款: Apache License 2.0
- 問題追蹤系統
- 原始碼
- 構建中介資料
- 可重現構建狀態
版本
雖然在下方可選擇下載 APK 檔案，但要留意這樣的安裝方式將不會收到更新通知，是一種較不安全的下載方法。建議您先安裝 F-Droid 用戶端使用。
下載 F-Droid-
此版本需要 Android 2.1 或更高的版本。
此套件包由 F-Droid 構建和簽署，並保證與此原始碼 Tarball 保持一致。